Flexible adhesive sealant for a variety of substrates. Seal pre-cast joins, manhole frames, adjusting rings and pipe penetrations:
Fast cure, high strength adhesive/sealant
Highly weather and corrosion resistant
Remains flexible to -40° F
Contains no solvents or isocyanates and is non-yellowing
Crystal-X® - Crystal-X seals out water and binds back dust, hardens and enhances the surface to resist abrasion. It becomes a part of the substrate, is non-toxic, resistant to aggressive chemicals, can be applied to the positive or the negative side of concrete, cannot puncture, tear or come apart at the seams and does not require a dry surface for application.
Flex Coat™ - Flex Coat can be used for resurfacing and sealing. It is a modified acrylic, cementitious resurfacing compound that remains flexible.
COR+GARD® Flex-Joint - This flexible adhesive sealant can be used with a variety of substrates such as pre-cast joints, manhole frames, adjusting rings and pipe penetrations. It will remain flexible to -40° F, is weather and corrosion resistant, cures quickly, contains no solvents or isocyanates and is non-yellowing.
COR+GARD® Cure 'N Seal- This curing product is fortified with ConShield® for protection against microbiologically induced corrosion (MIC) and gives visual verification of ConmicShield® use. It is a white pigmented wax-curing compound and forms a uniform film on concrete surfaces. It meets ASTM C-309, Type II, Class A and AASHTO M-148, Type II, Class A standards.
CS Identifier - CS Identifier is used to identify the use of ConShield® in concrete for protection against microbiologically induced corrosion (MIC). It forms a uniform film on concrete and mortar surfaces, is acrylic based and meets ASTM C-309 and C-1315 standards.
COR+GARD® ER - Cor+Gard® ER retards rapid evaporation of water from freshly placed mortars and concrete. It extends furgace finishing time and is very effective in windy, dry, curing conditions and may be topped with epoxy coatings.
COR+GARD Acryla Seal